If you move or are traveling within the country where your vehicle was purchased, Warranty or Service Bulletin repairs may be requested from any authorized Polaris dealer who sells the same line as your vehicle. Drain the sedi- ment tube. Place the handlebars in a straight-ahead position. Never remove your hands from the han- dlebars while operating, and always keep both feet on the footrests. Remove the three bolts and remove the arrestor from the end of the muffler. Eye Protection: Always wear shatterproof goggles or a helmet face shield, and always keep them clean so you can see where you're driving.
Axle and Wheel Nuts All nuts with a cotter pin installed must be service by an authorized Polaris dealer. The sealing strip cannot be removed. Avoid operating through deep or fast-flowing water. The tip should not be white. Avoid crossing the side of any hill unless absolutely necessary. Check your surroundings and determine your path of travel. Wash the oil pre-filter screen with solvent to remove debris.
Disconnect the black negative battery cable first. Remove the foam air filter. All pricing, specifications, claims, and information contained on this website are based upon current knowledge available at time of publication and are subject to change without notice, and Polaris assumes no responsibility for changes in pricing or specifications. If the kick-start lever is not installed, remove the lever from the under-seat storage area. Sit upright with both feet on the footrests and both hands on the handlebars. Always contact your dealer for service if throttle problems arise.
Position the vehicle on a level surface. Loosen the four rear housing mount bolts. Whenever riding a Polaris vehicle, always wear a helmet that meets or exceeds established safety standards. Whenever traveling uphill, fol- low these precautions: 1. While rotating the rear wheels, tighten the rear brake wing nut at the rear brake drum. Emission-Related Service Have an authorized Polaris dealer perform these services. Engine speed returns to idle when the lever is released.
When requesting warranty service you must present your copy of the Warranty Registration form to the dealer. Due to constant improvements in the design and quality of production components, some minor discrepancies may result between the actual vehicle and the information presented in this publication. If you receive any parts that appear to be damaged, blemished, or un-fit for your machine, please call us toll-free at 855 542-1616 or send us an email at returns wheelerpowersports. Telephone 763-542-0500 We, Polaris Industries Inc. Position the vehicle on a level surface. After I filled the tank it ran but not what you would expect out of Polaris, and after a while, even on the clean fuel it just would not run. Have an adult show you how it works.
Clean away any oil or sediments in the air box. The right lever controls the front brake. Has anyone touched one of these machines and could tell me if this is normal? An ignition key can be duplicated only by ordering a Polaris key blank using your key number and mating it with one of your existing keys. Allow it to idle for two to three minutes. Never add water to this type of battery. To top it off, while it was in the shop the battery apparently died and I had to replace that as well. Maintain the oil level in the proper range.
Place the transmission in gear. Upon receipt of this registration, Polaris will record the registration for warranty. If the filter is damaged, install a new foam filter. Be sure to read all of the following warnings about driving hazards and how to avoid them. Fill the fuel tank with gasoline. Always maintain a steady speed when climbing a hill. Wheel Hub Tightening Front wheel bearing tightness and spindle nut retention are critical component operations.
Always block the rear wheels on the downhill side as shown in the illus- tration. There are some things you can do and there are some things you must never do. It also prevents bacterial growth and promotes better starting after the storage period. Loosen the chain adjuster lock nut. No single action on your part is as important as following the procedures for a proper break-in. Never attempt wheelies, jumps, or other stunts. Lubricate more often under severe use, such as in dirty or wet conditions.
Call 800-342-3764 for additional information. This vehicle handles differently than other vehicles, such as motorcycles and cars. All information contained within this publication is based on the latest product information at the time of publication. Avoid steep hills 15 ° 2. Have an adult check the engine oil level when the engine is cold.